A leak under a sink or behind a ceiling starts with one valve
Before anything else, find the small valve under the sink or behind the toilet and turn it clockwise until it stops. If the leak is in a pipe with no valve nearby, or water is showing through a ceiling, close the main shut-off where the water line enters the basement. If water is near a light or an outlet, turn off that breaker and keep clear of it.
Once the water is off, most leaks can wait for a booked visit. A drip into a bucket under a trap is not urgent. Water you cannot stop with a valve, a bulging ceiling or a leak near electrics is, and that is a call to make now rather than in the morning. Put a towel down, take a photo for your records and leave the pipe as it is, so we can see where it is coming from.
Toilets and faucets usually fail in small, fixable ways
A toilet that runs on its own, refills every few minutes or rocks on the floor is almost always a worn flapper, a fill valve or a failed wax seal. A faucet that drips or will not shut off cleanly usually needs a cartridge or a washer, not a new faucet. These are routine repairs, and the part is often the only cost beyond the labour.
Tavistock's water comes from groundwater aquifers, and well-sourced water leaves mineral scale behind. Scale builds on fill valves, cartridges and aerators, and it is a common reason a fairly new fixture starts to stick or drip. We clean what can be cleaned and replace what cannot. If scale keeps coming back across the house, a water softener may be worth a conversation.
When we repair a shower or tub valve, we set the temperature limit as well. Ontario's Building Code limits water from a shower head or into a bathtub to 49 °C, and a worn or replaced mixing valve should be checked against it.
Outdoor taps split over the winter without showing it
An outdoor tap that froze in January often looks fine until the first time it is opened in spring. The split is usually inside the wall, so water runs into the basement or the wall cavity instead of the hose. If you open a tap and see water indoors, close it, then close the indoor valve that feeds it.
This one can usually wait for a booked visit once the indoor valve is off. We replace the damaged section and, where it suits the wall, fit a frost-resistant tap. Closing that indoor valve and draining the line each fall is the simplest way to avoid it next year.
Old galvanized and lead pipe can be identified without guesswork
The oldest houses in Tavistock, along the original streets such as Hope Street West and Woodstock Street North, were built around the turn of the twentieth century. Ontario houses of that age typically began with galvanized steel or lead water lines. Galvanized pipe corrodes from the inside, so pressure upstairs drops slowly over years and the water can run brown after it sits.
You can check part of this yourself. Look at the pipe where the water line enters the basement, before the meter. Lead is dull grey, soft enough to scratch shiny with a coin, and a magnet will not stick to it. Galvanized steel is harder, and a magnet will stick. If you are not sure, we look at it with you and say plainly what it is.
Ontario's drinking water standard for lead is a maximum of 0.010 milligrams per litre. If you find lead pipe, the next step is to plan a replacement. We explain which section is on your side of the property line, what replacing it involves and the price in writing, and you decide on timing.
Each era of house in the village has its usual repair
The Ben-Der Subdivision in the east of the village, with streets such as Bender Avenue, Homewood and Westwood, dates from the early 1970s. Houses of that era typically have copper water lines that are now ageing, with shut-off valves and fixtures that have worn. A valve that will not close fully, or a pinhole in copper near a fitting, are the repairs we expect to see there.
In the newest subdivisions, including Taylor Heights and The Orchards, water lines are typically PEX or copper. The pipe itself is young. Leaks there tend to come from a fitting, a supply line to a fixture or a scaled-up valve, and they are usually quick to find. Knowing which era the house is from lets us explain the likely cause on the first visit, before anything is opened up.
How a repair visit works
We ask what you have seen and when it started, then find the fault before recommending anything. If a small part will fix it, we say so. If the pipe behind the leak will not hold for long, we show you why and give you both options. You see the written price and approve it before any part is fitted. If you would like a price ahead of time, you can request a quote.
Work is performed by licensed plumbers (306A Certificate of Qualification), and plumbing in Ontario is governed by Part 7 of the Building Code. New plumbing and changes to drains generally need a building permit, and the municipal building department says whether a given job does. Our guide on doing your own plumbing in Ontario covers what a homeowner may take on. If the trouble is a slow or blocked drain rather than a leak, see drain cleaning.
