FAQ
Frequently asked questions
If your question is not here, ask us directly.

Drains and sewers
What is the best way to clean a main sewer line?
If the floor drain is backing up, stop using water in the house first. A main line is cleared mechanically, either with a cable run from a cleanout or with water under pressure. Chemicals are not used. Then the plumber finds out why it blocked. In Tavistock's oldest houses the lateral is often clay, and in the Ben-Der Subdivision roots find the joints. A camera shows which it is, and you can watch the footage yourself. Read how a main line is cleared.
Will dish soap and hot water clear a clogged drain?
Sometimes, when grease is slowing a kitchen sink. Squeeze some dish soap into the drain, follow it with hot tap water rather than boiling water, and give it time. It will not move hair, a solid object or roots. One slow fixture usually points to a local blockage. If several drains slow at once, or the floor drain gurgles, the main line is involved and soap will not reach the problem. Try the soap once, then see drain cleaning if the sink stays slow.
Does my house need a backwater valve?
Ontario's Building Code, Article 7.4.6.4., requires a backwater valve in construction where a drain may face backflow. That includes fixtures below the level of the adjoining street, and fixtures below the upstream sanitary manhole cover in a house on a public sewer. Many of Tavistock's oldest houses have a floor drain tied to the sewer and no valve at all, so a backup can come straight up. Look for an access cover in the basement floor near where the sewer leaves, then see sewer repair and backwater valves.
Water and water heaters
Is Tavistock's water from a well, and is it hard?
Tavistock is on a municipal system. Like the other Oxford County systems, it draws groundwater from underground aquifers. Southwestern Public Health lists naturally present sodium in Tavistock's water at 18.7 to 21.0 mg/L, which is worth knowing if you watch your sodium. We do not quote a hardness figure for Tavistock itself. Oxford County publishes 47 to 77 grains per gallon for its Innerkip system and notes that many households there use softeners. White crust on taps and kettles is the usual sign. Check your fixtures for that crust, then see water softeners.
Could my older Tavistock house still have a lead water line?
It is worth checking. The houses on the original village streets, such as Hope Street West and Woodstock Street North, date from around the turn of the twentieth century. Houses of that age often began with lead or galvanized steel water lines, though many have been replaced since. Lead is dull grey and soft enough to scratch shiny with a coin, and a magnet will not stick to it. Ontario's drinking water standard for lead is 0.010 milligrams per litre. Look at the pipe where it enters the basement, before the meter, then see plumbing repairs.
Why is the water pressure low in my Tavistock house?
The cause usually follows the age of the house. In the oldest houses it is often galvanized steel pipe that has corroded and narrowed from the inside. In the Ben-Der Subdivision, along Bender Avenue, Homewood and Westwood, it is more often a worn valve or a tired fixture. Hard groundwater can add scale to both. Testing the pressure at the main and then at the tap shows which one you have. Unscrew a faucet aerator first and check it for grit and scale, then see plumbing repairs.
Maintenance
Where is my sump pump allowed to drain in Tavistock?
Outside, away from the house. Oxford County's sanitary sewer design guidelines do not permit foundation drains, weeping tile or roof drainage to enter the sanitary sewer. Tavistock's sewers are a separated system feeding a lagoon plant. In the newer streets, such as Taylor Heights and The Orchards, weeping tile drains to a sump, so the pump runs often every spring. Before the melt, pour a pail of water into the pit. Watch the float lift and the pump empty it, then look at sump pumps.
Do I need a plumber to replace a sump pump?
It depends on what changes. Putting a matching pump on the same discharge is a smaller job than moving the pit or rerouting the discharge pipe. New plumbing and changes to drains generally need a permit, and the municipal building department says whether yours does. In Tavistock the discharge cannot go to the sanitary sewer. If you are replacing the pump anyway, it is a good time to add a battery backup. Check where your discharge pipe ends, then read our guide on doing your own plumbing and permits.
Emergencies and safety
Who do you call when a water pipe bursts?
Shut the water off first. The main valve is where the water line comes into the basement. Turn it clockwise until it stops, then open a low cold tap to drain the lines. If water is near an outlet or a light, turn off that breaker and stay clear. In Tavistock's oldest houses the basement floor drain is often tied straight to the sewer, so stop running water if it starts to back up. Once the water is off, the damage stops growing, and you can call a plumber. Find your main valve today, before you need it, and read what to do first when a pipe bursts.
Can anyone replace a gas water heater?
No. Ontario Regulation 212/01 sets out who may install and service gas appliances, and a gas water heater is one of them. Gas work is performed by TSSA-certified gas technicians. The temperature setting is regulated too: Ontario's Building Code limits water from a shower head or into a bathtub to 49 degrees Celsius. Hard groundwater also scales tanks over time, so the old unit is tested before anything is recommended. Note the age on your heater's rating label, then see water heaters.
General
Who is allowed to do plumbing work on a Tavistock house, and when is a permit needed?
Plumbing is a compulsory trade in Ontario, trade code 306A. The person doing the work must hold a Certificate of Qualification, a provisional certificate or a registered apprenticeship, and must appear on the Skilled Trades Ontario Public Register. You can search that register by name. New plumbing and changes to drains generally need a building permit, and the municipal building department says whether a given job does. Work is performed by licensed plumbers (306A Certificate of Qualification). Check the register before work starts, and read our guide to doing your own plumbing and permits.
How is the price of a plumbing repair worked out?
It depends on what the visit finds: which pipe, how much of it, the parts it needs and how easy it is to reach. A clay lateral under the lawn is a different job from a dripping valve under a sink. The plumber looks first and explains the cause. Then the price is written down, and you approve it before any part is fitted. If there are two sensible ways to fix it, you see both numbers and choose. Write down what the water is doing and since when, then request a quote.
Do I need a locate before digging up a sewer line?
Yes. In Ontario, a locate must be requested through Ontario Dig Authority before any digging, and the request costs you nothing. Public locates do not mark private lines, so the sewer lateral running from your house to the street will not be painted. A sewer camera fitted with a locating transmitter can trace that line instead. Request the locate before any shovel goes in, then see sewer repair and backwater valves.